Table of Contents
Advertisement
Hardware options
5-Hardware Options
XX, Menu:
The Advisor Master zone and output numbers are used in these records. All
numbers used in the ATS125x Installer programming menus should correspond
with the numbers used in the Advisor Master Installer menus, for example,
Menu 1, Zone Database, and menu 16, Event to outputs. See also "Short list of
available zones and outputs per DGP address" on page 50.
ATS125x, when assigned an address, automatically calculates its default zone
and output numbers (see the "Door/lift data hardware defaults" on page 51).
ATS125x/1260 has four onboard relays that by default are assigned as unlock
relays.
When assigning zone and output numbers to these functions, only numbers
associated with the DGP address can be entered. These ATS125x output
assignments only activate outputs connected to it.
If zones are disabled, they revert to being normal DGP system zones.
Any zones assigned as Door Contact zones or DOTL zones also have to be
assigned a zone type in the Advisor Master Installer menu 1, Zone Database
(defines how the Advisor Master responds to alarms on these zones).
Unlock output number
XX,Unlock Relay nn
*-Dis, 0/p:
This menu specifies the ATS125x output number to be activated when the door
is accessed. By default, this is one of the four onboard relays. The output number
specified refers to system output numbers (if using "Pulsed lock and unlock"
described on page 31, the output number is entered in this menu).
Zone number
XX, Zone nnn
*-Dis, Zone:
This menu specifies the zone number to be used for a Door contact on ATS125x
(if using "Pulsed lock and unlock" described on page 31, the zone number is
entered in this menu).
Monitor second door zone
XX,NO - Monitor 2nd Door Zone
*-Change
When programmed, the spare zone is used as a second door contact.
•
Yes: Treat the spare zone as second door contact.
ATS125x/1260 Four-Door/Four-Lift DGP Programming Guide
33
Advertisement
Table of Contents
