Table of Contents
Advertisement
Zones monitor floor selected
XX, NO - Zones Monitor Floor Selected
*-Change
This record enables ATS1260 zones to monitor the floor selected, up to a
maximum of 64 floors.
•
Yes: The ATS1260 zones may be used to monitor the floor selected, which
generates a report to the printer and computer. The zone range used is
configured in menu 2.6.6.If this option is set to "YES" then the "Security
Group Zone" Menu 2.6.8 cannot be used.
•
No: Zones are used as normal system alarm zones and the Security Group
Zone if enabled.
Wait for floor selection
No - Wait For Floor Selection
*-Change
Wait for floor selection before going on.
•
Yes: The lift will wait for only one floor to be selected before going on.
•
No: When the user is allowed access to multiple floors, multiple floors may be
selected.
First physical zone
XX,First Physical Zone 1
*-Dis, Zone:
This menu configures the starting zone number for the ATS1260 that will be used
to monitor the floors. When the user accesses a floor (a floor button pressed in
the lift), the ATS1260 will know which floor the user has selected. For example, if
this lift was controlling floors 1 to 8 (8 floors), and this option has been set to 9,
then zones 9 to 16 on the ATS1260 will be used to monitor the floors. Floor 1
uses zone 9; Floor 2 uses zone 10, etc.
The ATS1260 automatically calculates the last zone by the number of floors it is
controlling. The floor range is configured using the options "Starting Floor" and
"Last Floor".
Lift override group
XX, Lift Override Group Disabled
*-Dis, Grp:
Records a Floor group number. Each floor group is programmed with floors and
a timezone. The Lift Override Group determines floors that may be freely
accessed in the lift controls, and the times during which they can be disarmed
without using a valid card or PIN at the lift reader.
ATS125x/1260 Four-Door/Four-Lift DGP Programming Guide
37
Advertisement
Table of Contents
