Table of Contents
Advertisement
Important information
This manual provides detailed explanations for programming the ATS125x/1260
and includes detailed explanations for the entire door / lift menus. All references
to the programming menus, and their numbers, are menus within programming
Remote Devices, Installer menu 28, and Titan Advisor Master > To Remote
Devices > DGP.
When installing a new 4-Door/4-Lift DGP, it is strongly recommended that you
first initialise the ATS125x/1260 using Menu 3 - Initialise Database. This step
may only be accomplished by programming using a RAS on the system databus
of the Advisor Master. It will set all programming to factory default; as listed in
this programming manual. Once initialised, the DGP may be programmed using
a RAS or a PC running TITAN software.
The ATS1250 and ATS1260 are the same physical products except for the
firmware (software) EPROM. The factory defaults are different for each product
and are listed in the programming sheets in this guide.
Whenever the ATS125x is mentioned, ATS1250, ATS1251, ATS1252, ATS1253,
ATS1254, and ATS1260 are included except where explicitly stated.
ATS125x/1260 Four-Door/Four-Lift DGP Programming Guide
iii
Advertisement
Table of Contents
