Honda BF40D Manual page 608

24) After installing the grip rubber, operate the throttle grip and
check that the "
fully open position or full close position ("
1
throttle mark.
2
If not, remove the grip rubber once and install it again.
3
4
5
6
25) Apply marine grease to the side and outer surface of the steering handle bushings and to the inner wall of the
housing. Install the steering handle bushings on the tiller handle assembly.
7
Apply marine grease to the 12 mm washer [large]. Set the 12 mm washer [large] in the position shown, and install
the steering bracket on the tiller handle assembly.
8
26) Install the 12 mm washer [small], 12 x 80 mm hex bolt, 12.2 x 23 x 16 mm distance collar, 14 mm wave washer and
the 12 mm hex nut [large], and tighten the 12 x 80 mm hex bolt to the specified torque.
9
TORQUE: 29 N . m (3.0 kgf . m, 21 lbf . ft)
10
• Check that the threads of the 12 x 80 mm hex bolt are not contaminated with marine grease.
27) Tighten the 12 mm hex nut [small] against the 12 x 80 mm hex bolt.
11
Holding the 12 x 80 mm hex bolt, tighten the 12 mm hex nut [small] to the specified torque.
12
TORQUE: 54 N . m (5.5 kgf . m, 40 lbf . ft)
28) Set the height adjusting block on the steering bracket, and tighten the 8 x 28 mm flange bolt to the specified torque.
13
TORQUE: 26.5 N . m (2.7 kgf . m, 20 lbf . ft)
14
15
16
17
[11]
12 mm HEX NUT
[SMALL]
18
[10]
14 mm WAVE
19
WASHER
20
[9]
HEIGHT ADJUSTING
BLOCK
8 x 28
[8]
12 mm WASHER
[LARGE]
16-25
" mark on the grip rubber aligns with the
" mark) of the
[1]
12 mm HEX NUT
[LARGE]
[2]
(MARINE
GREASE)
[2]
(MARINE GREASE)
[2] FULL OPEN
POSITION
[1]
GRIP RUBBER
[5] "
[3]
12.2 x 23 x 16 mm
DISTANCE COLLAR
[5]
12 mm WASHER
[SMALL]
[7]
STEERING HANDLE
BUSHING (2)
608
[3]
THROTTLE
MARK
[4]
FULL CLOSE
POSITION
( MARK)
" MARK
[4]
STEERING
BRACKET
[6]
12 x 80 mm
HEX BOLT