Opening Air-Fi Network; Configuring Wcs Sensor; Creating Points To The Sensor - Trane Air-Fi WCS-SB Installation, Operation And Maintenance Manual

Using the Tracer® TU Service Tool with a Wireless Network
4. Click the check mark when finished configuring that sensor.
5. Click the trash can icon to delete a sensor.
6. Click the pencil icon to edit the sensor configuration.
Note: Up to 6 sensors can be directly connected to the SC+ for each network.

Opening Air-Fi Network

1. Ensure that the network is open
2. From Tracer TU, select "Wireless/Open network"
3. Select the network to open, then click OK
Note: The network can also be opened at the coordinator by pressing the Open Net button.

Configuring WCS Sensor

1. Hold the Addr button for 3 seconds
2. Set to Group/Net using the up down and next buttons
3. Set the UC Address for 000, not the rotary address of the SC+
4. Select next to set the Sensor# (1-6)
5. Hold the Addr button for 3 seconds to exit addressing mode
6. From a blank display press the up arrow to force the WCS to join the network

Creating Points to the Sensor

1. In Tracer SC+, navigate to "Points", then "Create Points" from the top of the Page.
2. Select the point type that is needed for the value, typically "Analog Input".
Figure 66. Creating points in Tracer SC+
3. Define the Name, Units and select the Referencer.
102
To change the selection of points, click on the referencer icons.
BAS-SVX40K-EN