Wcs-So, -Sco 2 , -Sb/R Display Sequence - Trane Air-Fi WCS-SB Installation, Operation And Maintenance Manual

WCS–SO/SCO and –SB/R Installation
2
WCS-SO, -SCO
Note: WCS-SO/SCO
Use the NEXT and Address (ADDR) buttons to move forward or back through the sensor display
sequence. Use the UP and DOWN arrows to toggle between units and increase or decrease values in
their given increments.
Pressing the NEXT button repeatedly displays the following conditions in this order:
1. Blank Screen or Errors
2. CO
3. Temperature
4. Temperature offset
5. Humidity (optional)
6. Humidity Offset (optional)
7. Motion Test (optional)
8. Back to top
Note: Pressing the ADDR button will act like a BACK button, so you can go through the options in
Blank Screen or Errors
This screen is blank if there are no errors present. If an error is present, it will be displayed until the error
condition is resolved, then the screen will be blank.
CO
Displays the CO
Note: It takes eight (8) days for a newly installed CO
48
, -SB/R Display Sequence
2
sensors do not have set point, timed override, fan mode or system mode. If you
2
need these features you will have to add a WCS-SD display sensor.
(optional)
2
reverse.
2
level in parts per million (ppm).
2
complete a calibration cycle.
sensor to acclimate to the environment and
2
BAS-SVX40K-EN