WCS-SB/SD Configuration
6. To return the display to operating mode, press the configuration button, press the center button on
Example of a Configured WCS-SD Display
The following example shows a configured display in operating mode.
If an error code exists, it appears at the bottom center of the display, as shown below. View definitions
on the inside of the back plate or see "Sensor does not communicate with WCI." under
and Maintenance," p.
Optional Features
Perform the following procedures as needed.
Displaying Setpoint or Temperature
You can configure the sensor to display either the temperature (default) or the setpoint. To select either
option:
1. Verify that the sensor is in operating mode and that the home screen is displayed.
2. Toggle between the temperature and setpoint screens by pressing the up and down arrows for 3
56
The example shows a display that has been configured for:
•
Dual setpoint
•
Temperature units (Fahrenheit)
•
Temperature resolution to tenths of a degree
•
System settings: Emergency Heat, Heat, Cool, Off
•
Fan settings: Auto or On
•
Occupied/unoccupied option enabled
the keypad once.
Note: The sensor will revert to operating mode if no buttons are pressed for 10 minutes.
70.
seconds. The arrow to the left of the temperature indicates that it is the setpoint.
Display shows the following:
•
Temperature units (Fahrenheit)
•
Temperature resolution to tenths of a degree
•
System setting: Cooling
•
Fan setting: Auto
•
Occupied/Unoccupied option enabled
"Troubleshooting
BAS-SVX40K-EN