Cleaning The Module; Bearing And Motor Lubrication; Energy Wheel Drive Belt Adjustment; Air Filters - Trane CLCH-SVX02C-EN Installation Operation & Maintenance

Cleaning the
Module
1. Disconnect all electrical power.
2. Use a vacuum cleaner to remove
dust and debris from the module
surfaces.
3. If needed, use a detergent
solution to remove grease, oil, or
other stubborn deposits from
module surfaces. Follow the
manufacturer's instructions
regarding use of the product.
4. Rinse any cleaning product
thoroughly from the module
walls. The use of a water stream
from a garden hose or high
pressure washer is not
recommended. Saturation of the
wall panel insulation with
potential microbial growth or
damage to the energy wheel
could occur.
5. Examine the module monthly for
material build-up on the wall
surfaces.
Bearing and Motor
Lubrication
The wheel drive motor and wheel
support shaft bearings are
permanently lubricated and no
further lubrication is necessary.
CLCH-SVX02C-EN
Routine Maintenance
Energy Wheel Drive
Belt Adjustment
The drive belt is a urethane stretch
belt designed to provide constant
tension throughout the life of the
belt. No periodic adjustment is
required. Inspect the belt annually
for proper tracking and tension. A
properly tensioned belt will turn the
wheel immediately, with no visible
slippage, when power is applied.

Air Filters

Energy wheel modules are available
with 2-inch filters only. Refer to
product catalog CLCH-PRC003-EN
for filter sizes, types, and quantities.
WARNING
Hazardous Voltage!
Disconnect all electric power,
including remote disconnects before
servicing. Follow proper lockout/
tagout procedures to ensure the
power can not be inadvertently
energized. Failure to disconnect
power before servicing could result
in death or serious injury.
Throwaway Filters
To replace throwaway filters, install
new filters with the directional
arrows pointing in the direction of
airflow.
Permanent Filters
To clean permanent filters:
1. Disconnect all electrical power to
the unit.
2. Wash the filter under a stream of
water to remove dirt and lint.
3. Remove oil from the filter with a
wash of mild alkali solution.
4. Rinse the filter in clean, hot water
and allow to dry.
5. Coat both sides of the filter by
immersing or spraying it with Air
Maze Filter Lote W or an
equivalent.
6. Allow to drain and dry for about
12 hours.
7. Reinstall the filter.
Note: It may be preferable to keep
extra, clean filters to replace the dirty
filters to minimize unit downtime for
filter maintenance.
15