Trane Air-Fi WCS-SB Installation, Operation And Maintenance Manual page 90

Using the Tracer® TU Service Tool with a Wireless Network
Note: If using BACnet references to share Space Temp Local or Space Temperature Setpoint Local, the
Other types of sensors can be set up in a similar manner:
•
•
•
When using multiple sensors, you must create additional points in the UC to see these values in both
Tracer TU and the Tracer SC. To reference individual values, navigate to the Point Configuration tab of
an existing or newly created point (see the "Creating a New Point" topic in the "Configuring and
Managing Points" section of the Tracer TU Help for Programmable Controllers). Use the Point
Configuration tab shown in
Figure 62, p. 91
Figure 61. Point Configuration Tab — Analog Input Properties dialog box
90
Enable Wireless Space Sensors box must be unchecked or the reference will revert to wci.
spaceTemp or wci.coolSetpoint on a power cycle or reboot. The same applies to humidity, CO
and Occupancy.
The Enable Wireless Humidity Sensor check box works the same as the Enable Wireless Space
Sensors box described above. Selecting the check box provides the average humidity of all
associated humidity sensors, which is displayed in Space Humidity Local. If the box is not selected,
you can reference an individual sensor.
Selecting the Enable Wireless CO
wireless CO sensors, which is displayed in Space CO
2
checked, you can reference an individual CO
If the Enable Wireless Occupancy Sensor check box is checked, the controller will go occupied
when any occupancy sensor detects motion. The binary value is displayed in Occupancy Input on
the Binary screen. If the box is unchecked, individual sensors can be referenced.
Figure 61, p. 90
to create the references.
Sensor check box gives the maximum value of all associated
2
Concentration Local. If the box is not
2
sensor.
2
and the Reference dialog box drop-down as shown in
2
BAS-SVX40K-EN