Network Information; Portal Configuration - Trane TR1 Series VFD BACnet Installation And Operation Manual

CSO FIRM
CSO PO #
CSO CONTACT
CSO PHONE
Each BACnet portal can control and monitor any mix of TR1 Series VFDs up to a total of ten.
Use separate BACnet Communications Site Survey sheet for each portal.

NETWORK INFORMATION

BACnet can communicate over all of the following networks. Indicate the network that will be used.
*Ethernet IP
PTP over EIA-232 (RS-232)
*Supported by Tracer Summit.

PORTAL CONFIGURATION

The following information is required to program the portal. Network number must be supplied in all cases.
Device Instance Number: ____________ Supply number for TR1 BACnet portal in all cases.
Ethernet IP
IP Network Number: ____________ Supply user's network number in all cases.
Use default IP address.
Default address range is: 192.168.168.001
Default Subnet Mask is: 255.255.255.0
Default Gateway Address is: 0.0.0.0
Use specified IP address.
You must specify the following.
IP address: __ __ __ . __ __ __ . __ __ __ . __ __ __
Subnet mask: __ __ __ . __ __ __ . __ __ __ . __
Gateway Address: __ . __ . __ . __
Ethernet (not routable)
Ethernet Network Number: ____________ Must match user's network number.
ARCnet
Network Number: ____________ Must match user's network number.
PTP over EIA-232 (RS-232)
Network Number: ____________ Must be different than other network numbers.
MSTP over EIA-485 (RS-485)
2-wire (default)
Network Number: ____________ Must match user's network number.
Master Station
Master Station ID: __________ Default is 127. Range is 0 through 127.
Baud Rate (default is 9600)
Slave Station
Slave Station ID: __________ Default is 127. Range is 0 through 254.
Baud Rate (default is 9600)
22
BACnet Communications Site Survey
*Ethernet ARCnet (156K twisted pair)
MSTP over EIA-485 (RS-485)
4-wire
9600 38400
9600 38400