Table of Contents
Advertisement
Figure 62. Reference dialog box
BCI/BCI2 Point and Reference Limitations
It is not possible to create points or references in any BCI/BCI2. This section explains considerations to
keep in mind about the following points:
•
•
BAS-SVX40K-EN
Using the Tracer® TU Service Tool with a Wireless Network
Space Temperature
If using a BCI/BCI2 with multiple sensors, you will not be able to see the individual temperature
values from the WCS. You will only see the average Space Temperature reported as the Space
Temperature Active. BCI/BCI2s do not allow additional points to be created to read the individual
sensor values.
Space Temperature Setpoint
–
In both BCI-R/BCI2-Rs and BCI-I/BCI2s, the space setpoint is the value of the last change in
setpoint if more than one WCS is used.
–
If you do not wish a WCS to provide a setpoint change, do not configure the sensor for setpoint
control.
–
The BCI-R/BCI2-R will only use Air-Fi sensor values if in BAS Control. To put BCI-R/BCI2-R in
BAS Control you put BO-1 System Control Command point into BAS Control and In Service.
•
BCI-R/BCI2-R
•
Space Setpoints BCI-R/BCI2-R using Air-Fi with Occupied Offset in Service
•
Cooling Setpoint Active = Last change in setpoint from Air-Fi sensor + Offset
91
Hide quick links:
Advertisement
Table of Contents
