Changing The Swingarm Bearing - Husqvarna FE 350 2014 Repair Manual

SHOCK ABSORBER, SWINGARM
9

Changing the swingarm bearing

Info
These operations are the same on both swingarm bearings.
-
Position the engine sprocket cover and mount in the holder.
Mount and tighten screws
Guideline
I
Screw, clutch slave cylinder
Mount and tighten screws
I Guideline
Remaining screws, chassis
-
Position the brake caliper and pull it back.
-
Position the brake line in the guide.
Finishing work
-
Install the rear wheel. (or p. 91)
-
Remove the motorcycle from the lift stand. (or p. 11)
Preparatory work
-
Raise the motorcycle with a lift stand. (or p. 11)
-
Remove the rear wheel. (or p. 90)
-
Remove the swingarm. (or p. 63)
8.
0-
65
10 Nm (7.4 lbf ft)
I I
25 Nm (18.4 lbf ft)