Fluke 5520A Operator's Manual page 250

5520A
Operators Manual
STBY
(Standby command) Deactivates the Calibrator output if it is in operate. This is the same
as pressing the Calibrator front panel Y key.
Parameter:
Example:
Disconnect the selected output from the Calibrator front panel terminals.
SYNCOUT
(Synchronization Pulse command) Sends a synchronization pulse out to a slave
Calibrator through the 10 MHZ OUT BNC connector.
Parameter:
Example:
TC_MEAS
(Thermocouple Measure command) Selects the measure thermocouple mode.
Parameters: CEL
Example:
Measure the thermocouple temperature that is attached to the Calibrator TC terminals, in
Celsius.
TC_OFFSET
(Thermocouple Temperature Measurement Offset command) Adds a temperature offset
to thermocouple measurements (±500 °C). This command does not apply to
thermocouple sourcing.
Parameters: <value> CEL
Example:
Add a temperature offset of +10 °C to the thermocouple measurements.
TC_OFFSET?
(Thermocouple Temperature Measurement Offset query) Returns the temperature offset
used for thermocouple measurements (±500 °C).
Responses:
Example:
Returns 10 Celsius when a temperature offset of +10 °C has been added to the
thermocouple measurements.
6-46
x x
IEEE-488 RS-232
(None)
STBY
x x
IEEE-488 RS-232
(None)
SYNCOUT
x x
IEEE-488 RS-232
(Celsius) (optional)
(Fahrenheit) (optional)
FAR
TC_MEAS CEL
x x
IEEE-488
<value> FAR
TC_O+FFSET +10 CEL
x
IEEE-488
<value> CEL
<value> FAR
TC_OFFSET? returns 1.000E+01,CEL
x x
Sequential Overlapped
x
Sequential
x
Sequential
x
RS-232 Sequential
(offset in Celsius) (optional)
(offset in Fahrenheit) (optional)
x x
RS-232 Sequential
(offset in Celsius) (optional)
(offset in Fahrenheit) (optional)
x
Coupled
x x
Overlapped Coupled
x
x
Overlapped
Coupled
x x
Overlapped Coupled
x
x
Overlapped Coupled