Fluke 5520A Operator's Manual page 244

5520A
Operators Manual
RPT_STR
(Report String command) Loads the user report string. The user report string can be read
on the Control Display in local operation, and appears on calibration reports. The
CALIBRATION switch must be set to ENABLE. (Sequential command.)
Parameter:
RPT_STR?
(Report String query) Returns the user report string. The user report string can be read
on the Control Display in local operation, and appears on calibration reports. (Sequential
command.)
Parameter:
Response:
*RST
(Reset Instrument command) Resets the Calibrator to the power-up state. *RST holds
off execution of subsequent commands until the reset operation is complete. This
command is the same as pressing the front panel R key.
A reset action evokes the following commands and values:
Command
CUR_POST
DBMZ
DC_OFFSET
DUTY
EARTH
EXTGUARD
HARMONIC
LCOMP
LOWS
OUT
OUT_IMP
PHASE
PRES_UNIT
RANGELCK
Changes made to the setup menus that are not saved in memory are discarded on reset.
Response:
6-40
x x
IEEE-488 RS-232
String of up to 40 characters
x x
IEEE-488
None
(String) Up to 40 characters
x x
IEEE-488 RS-232
Value
AUX
<DBMZ_D value>
0V
50PCT
OPEN
OFF
1, PRI
OFF
TIED
0V,0HZ
Z1M
0DEG
<PRES_UNIT_D value>
OFF
(None)
x x
Sequential
x
RS-232 Sequential
x x
Sequential Overlapped
Command
REFCLOCK
REFPHASE
RTD_TYPE
SCOPE
STBY
TC_OFFSET
TC_OTCD
TC_REF
TC_TYPE
TRIG
TSENS_TYPE
WAVE
ZCOMP
ZERO_MEAS
x
Overlapped Coupled
x x
Overlapped Coupled
x
Coupled
Value
<REFCLOCK_D value>
<REFPHASE_D value>
<RTD_TYPE_D value>
OFF
(No output)
0 CEL
ON
INT
<TC_TYPE_D value>
OFF
TC
NONE,NONE
OFF
OFF