Fluke 5520A Operator's Manual page 171

1. Turn the Calibrator power on. You may operate the Calibrator during warmup, but
specifications are not guaranteed until warmup is complete.
2. Press S on the Calibrator front panel.
3. Negotiate the softkey selections shown below to configure the UUT serial port to
match the settings of the UUT RS-232 port. The factory defaults (shown below in
bold) are 9600 baud, 8 data bits, 1 stop bit, and no parity. Other parameters include
flow control (STALL).
Setting up the RS-232 UUT Port for Remote Control
Remote Operation
nn125f.eps
5
5-17