Specifications - Fluke 5520A Operator's Manual

1-12. Specifications

The following tables list the 5520A specifications. All specifications are valid after
allowing a warm-up period of 30 minutes, or twice the time the 5520A has been turned
off. (For example, if the 5520A has been turned off for 5 minutes, the warm-up period is
10 minutes.)
All specifications apply for the temperature and time period indicated. For temperatures
±5 °C (t
outside of t
cal
temperature coefficient as stated in the General Specifications must be applied.
The specifications also assume the Calibrator is zeroed every seven days or whenever the
ambient temperature changes more than 5 °C. The tightest ohms specifications are
maintained with a zero cal every 12 hours within ±1 °C of use. (See "Zeroing the
Calibrator" in Chapter 4.)
Also see additional specifications later in this chapter for information on extended
specifications for ac voltage and current. The dimensional outline for the 5520A
Calibrator is shown in Figure 1-3.
5520A CALIBRATOR
NORMAL AUX SCOPE
V, , ,RTD A, -SENSE, AUX V
OUT
STBY
HI
7
LO
TRIG
4
GUARD 20A
1
/ +
20V PK MAX TC 20V PK MAX
is the ambient temperature when the 5520A was calibrated), the
cal
43.2 cm (17 in)
PREV
OPR EARTH EXGRD SCOPE MENU
µ
dBm sec
8 9 SETUP RESET
m V Hz
n W
¡F NEW
5 6 CE
k A ¡C
REF
p
MEAS MORE
2 3
M F
TC MODES
MULT DIV
0 • ENTER
SHIFT ÷
x
47.0 cm (18.5 in)
Figure 1-3. 5520A Calibrator Dimensional Outline
Introduction and Specifications
17.8 cm
(7 in)
EDIT
FIELD
POWER
I
O
Specifications
6.4 cm
(2.5 in)
For Cable
Access
nn032f.eps
1
1-9