Fluke 5520A Operator's Manual page 166

5520A
Operators Manual
4. Negotiate the softkey selections shown below to select the HOST serial port
5. Press P (not E ) several times until the message STORE
5-12
parameters to match the PC COM parameters. (Individual softkey functions are
discussed in Chapter 3, "Features.") If operating the port with a computer program
instead of individual commands from a terminal, select Remote I/F comp.
CHANGES/DISCARD CHANGES appears or, if there were no changes, the reset
display. If you select STORE CHANGES, the serial and host port setting are saved
in the instrument non-volatile memory.
nn122f.eps