JLG 1200SJP Service Maintenance Manual page 459
Hide thumbs
Also See for 1200SJP:
- Service and maintenance manual (184 pages) ,
- Operation and safety manual (152 pages) ,
- Quick reference (1 page)
Table of Contents
Advertisement
Flash
DTC
Sequence
Code
2211
22
11
2212
22
12
2213
22
13
2215
22
15
2216
22
16
2217
22
17
2218
22
18
2219
22
19
2220
22
20
2221
22
21
2222
22
22
2223
22
23
2224
22
24
230
23
0
234
23
4
235
23
5
3121142
Table 6-6. Diagnostic Trouble Code Chart
Fault Message
FSW INTERLOCK TRIPPED
DRIVE LOCKED - JOYSTICK MOVED BEFORE FOOTSWITCH
STEER LOCKED - SELECTED BEFORE FOOTSWITCH
D/S JOY. OUT OF RANGE LOW
D/S JOY. OUT OF RANGE HIGH
D/S JOY. CENTER TAP BAD
L/S JOY. OUT OF RANGE LOW
L/S JOY. OUT OF RANGE HIGH
L/S JOY. CENTER TAP BAD
LIFT/SWING LOCKED - JOYSTICK MOVED BEFORE FOOTSWITCH
WAITING FOR FSW TO BE OPEN
FUNCTION SWITCHES LOCKED - SELECTED BEFORE ENABLE
FOOTSWITCH SELECTED BEFORE START
<<< GROUND CONTROLS >>>
FUNCTION SWITCHES FAULTY - CHECK DIAGNOSTICS/BOOM
FUNCTION SWITCHES LOCKED - SELECTED BEFORE AUX POWER
Fault Description
The Footswitch was closed for
more then seven seconds.
A drive function was selected
with Footswitch open.
A steer function was selected
with Footswitch open.
The D/S Joystick reference volt-
age is low.
The D/S Joystick reference volt-
age is > 8.1V.
The D/S Joystick center tap volt-
age is < 3.08V or > 3.83V.
The L/S Joystick reference volt-
age is low.
The L/S Joystick reference volt-
age is > 8.1V.
The L/S Joystick center tap volt-
age is < 3.08V or > 3.83V.
A lift / swing function was
selected with Footswitch open.
The Footswitch was closed dur-
ing Platform selection.
A boom function was selected
with Footswitch open.
The Footswitch was closed dur-
ing engine start.
A boom function has both direc-
tions selected together.
A boom function was selected
before aux power.
– JLG Lift –
SECTION 6 - JLG CONTROL SYSTEM
Check
- Can be reported during power-
up.
- Can be reported during power-
up.
- Resistive joysticks, these faults
do not occur.
- Resistive joysticks.
- If the reference voltage is > 7.7V
then the reference voltage is out
of tolerance of a short to battery
has occurred.
- Resistive joysticks.
- There is a +/- .1V range. around
these values due to resistor toler-
ances
- Resistive joysticks, these faults
do not occur.
- Resistive joysticks.
- If the reference voltage is > 7.7V
then the reference voltage is out
of tolerance of a short to battery
has occurred.
- Resistive joysticks.
- There is a +/- .1V range. around
these values due to resistor toler-
ances
- Can be reported during power-
up.
6-83
Advertisement
Chapters
Table of Contents
Troubleshooting
