JLG 1200SJP Service Maintenance Manual page 318

SECTION 4 - BOOM & PLATFORM
2. Install the thrust washer (304) onto shaft (2) and end cap
(4).
3. Install the wiper seal (304.1/green 0-ring) into it's groove
on the shaft (2) and end cap (4) around the outside edge
of the thrust washer (304).
4-84
4. Using a seal tool install the main pressure seal (205) onto
shaft (2) and end cap (4). Use the seal tool in a circular
motion.
5. Install the wear guide (302) on the end cap (4) and shaft
(2).
6. Install the inner T-seal (200) into the piston (3) using a
circular motion.
Install the outer T-seal (202) by stretching it around the
groove in a circular motion.
– JLG Lift – 3121142