JLG 1200SJP Service Maintenance Manual page 412

SECTION 6 - JLG CONTROL SYSTEM
Diagnostics Submenu
Parameter (Displayed on
(Displayed on Analyzer
Analyzer 2
st
1 Line)
DRIVE:
DRIVE
STEER
4WS
BRAKES
CREEP
CRP MODE
QPRX1
QPRX2
TWO SPEED
2 speed mode
high engine
LT F ANG
RT F ANG
LT R ANG
RT R ANG
DOS LIM sw
DOS O/R sw
6-36
Table 6-5. Machine Diagnostics Parameters
Parameter Value
nd
Line) (Displayed on Analyzer 2
FOR/REV XXX%
RIGHT/LEFT XXX%
NORMAL/COOR/CRAB
LOCKED/RELEASED
ACTIVE/NOT ACTIVE
ACTIVE/NOT ACT
ACTIVE/NOT ACTIVE
ACTIVE/NOT ACTIVE
OP/CL
ON/OFF
OP/CL
XX.X
XX.X
XX.X
XX.X
OP/CL
OP/CL
– JLG Lift –
nd
Line)
Displays drive joystick direction & demand
Displays steer switch direction & demand
Displays status of four wheel steer input (Displayed if 4WS = 1)
Displays brake control system status
Displays pump pot creep switch status
Displays creep mode status
Displays status of Q-Prox sensor in drive joystick (Displayed if JOYSTICK TYPE =
1)
Displays status of Q-Prox sensor in drive joystick (Displayed if JOYSTICK TYPE =
1)
Displays status of two speed switch input if selected model has two speed.
Displays status of two speed valve if selected model has two speed
Displays status of high engine switch
Displays status of left front steer angle (Displayed if MODEL NUMBER = 7 or 8)
Displays status of right front steer angle (Displayed if MODEL NUMBER = 7 or
8)
Displays status of left rear steer angle (Displayed if MODEL NUMBER = 7 or 8)
Displays status of right rear steer angle (Displayed if MODEL NUMBER = 7 or 8)
Displays status of Drive Orientation System limit switch. (Displayed if MODEL
NUMBER = 7 or 8)
Displays status of Drive Orientation Limit System override switch. (Displayed if
MODEL NUMBER = 7 or 8)
Description
3121142