JLG 1200SJP Service Maintenance Manual page 415

Diagnostics Submenu
Parameter (Displayed on
(Displayed on Analyzer
Analyzer 2
st
1 Line)
SYSTEM:
GM BATTERY
PM BATTERY
AMB. TEMP
FSW1
FSW2
ABOVE ELEV.
LEN SW 1
LEN SW 2
RETRACTED
TRANSPORT
U LIFT CUTOUT
T LIFT PROX
T TELE PROX
BR CABLE CUT.
CREEP
CRP MODE
SUPER CREEP
TILT
LO TILTED -
3121142
Table 6-5. Machine Diagnostics Parameters
Parameter Value
nd
Line) (Displayed on Analyzer 2
XX.XV
XX.XV
XXXC
OP/CL
OP/CL
OP/CL/YES/NO
OP/CL
OP/CL
YES/NO
YES/NO
OP/CL
OP/CL
OP/CL
OP/CL
ACTIVE/NOT ACTIVE
ACTIVE/NOT ACT
ON/OFF
XX.X DEG
NO/YES
– JLG Lift –
SECTION 6 - JLG CONTROL SYSTEM
nd
Line)
Ground module battery voltage
Platform module battery voltage
Ambient temperature
Displays footswitch status. NOTE: FSW1 is wired to the ground module.
Displays footswitch status. NOTE: FSW2 is wired to the platform module.
Displays above elevation cutout switch status or above angle status
Displays status of boom length retracted limit switch (Displayed if MODEL
NUMBER = 7 or 8)
Displays status of boom length retracted limit switch (Displayed if MODEL
NUMBER = 7 or 8)
Displays status of boom length retracted (Displayed if MODEL NUMBER = 7 or
8)
Displays status of transport position
Displays status of boom length retracted limit switch (Displayed if MODEL
NUMBER = 6)
Displays status of tower lift proximity switch (Displayed if TOWER PROX
SWITCHES = 1)
Displays status of tower telescope proximity switch (Displayed if TOWER PROX
SWITCHES = 1)
Displays status of broken cable switch (Displayed if BROKEN CABLE SWITCH =
1)
Displays pump pot creep switch status. Not displayed if MODEL = 601
(machine digit = 4)
Displays creep mode status
Displays super creep mode status (Displayed if MODEL NUMBER = 7 or 8)
Displays measured vehicle tilt. (Displayed if internal tilt sensor is configured)
Displays status of lo tilt input. (Displayed if external tilt sensor is configured)
Description
6-39