JLG 1200SJP Service Maintenance Manual page 267

16. Feed the fly boom retract cable into the inner mid boom
section from the front.
17. Using an adequate lifting device, align the outer mid
boom section with the inner mid boom section.
3121142
18. Attach the fly boom retract cables in the inner mid
boom section to the receptacles at the rear of the outer
mid boom section.
19. Put tape over the holes to keep the cable ends from
jumping out.
20. Push the outer mid assembly part way into the inner
mid boom section. Apply JLG Threadlocker P/N 0100011
to the bolts and install the front bottom wear pad into
the inner mid boom section. Torque the bolts to 50
ft.lbs. (68 Nm).
– JLG Lift –
SECTION 4 - BOOM & PLATFORM
4-33