Job Recall - Canon imageCLASS MF7460 Reference Manual

Before Using the
Machine 1

Job Recall

Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
You can recall the last three destinations, scan settings, and
send settings that have been set, and then send your
documents.
– The machine considers any one of the following operations a send job:
– When settings, such as the destination, scan settings, and send
settings, are specified, and the control panel power switch,
(Reset) is pressed
– When the Auto Clear mode activates after the send settings are
specified
– The Standard mode is not stored in Recall memory.
– The three most recent settings that were stored in memory are not
erased even when the power is turned off.
1.
Press (SEND).
2.
Place your originals.
3.
Press [Recall].
4.
Select [1 Before], [2 Before], or [3 Before],
confirm the settings, then press [OK].
– If there are more stored Send settings than are currently
displayed, you can scroll through the list by pressing [▼] or [▲].
– You can change the settings for a recalled send job.
– If there are multiple destinations stored in Recall memory, the
order of the destinations shown in the list may not correspond to
the order in which they were specified.
5.
Press
If the original is placed on the platen glass, follow the instructions
that appear on the touch panel display, then press
each original. When scanning is complete, press [Done].
Scanning starts.
The scanned data is sent to the specified destination when scanning
is complete.
(Start), or
Back Previous Next
(Start).
TOP
(Start) once for
4-37