Canon imageCLASS MF7460 Reference Manual page 86

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Page Order (Collate)
■
1.
Press (COPY) .
2.
Place your originals.
3.
Press [Finishing].
4.
Press [Collate].
If you want to rotate the output sheet, press [Rotate] and proceed to
step 5. Otherwise, press [OK] and skip to step 7.
5.
Press [NEXT].
6.
Select [A4], [A4R], [B5], [B5R], [LTR], or [LTRR],
then press [OK].
– [Rotate] can be selected only in the following cases:
– If the available paper size is selected manually
– If the available paper size is loaded in both the horizontal and
vertical directions
– The selected paper source must have Drawer Eligibility For
APS/ADS in Common Settings (from the Additional Functions
screen) set to [On] . (See "Drawer Eligibility For APS/ADS, " on
p. 11-6.)
– When you have selected Automatic Paper Selection for the
Rotate mode, make sure to select a paper size which can be
rotated. Otherwise, output will not be rotated.
– If there is no paper which can be rotated, output will be collated.
Back Previous
7.
Press (Start).
If the original is placed on the platen glass, follow the instructions
that appear on the touch panel display. Press
original. When scanning is complete, press [Done].
– To cancel this setting, press [Finishing], then press [Cancel].
– To cancel all settings and return the machine to the Standard
mode, press (Reset).
Same Page ( Group)
■
1.
Press (COPY) .
2.
Place your originals.
3.
Press [Finishing].
4.
Press [Group], then press [OK].
If you want to rotate the output sheet, press [Rotate] and proceed to
step 5. Otherwise, skip to step 7.
5.
Press [NEXT].
TOP
Next
(Start) once for each
3-15