Canon imageCLASS MF7460 Reference Manual page 350

Before Using the
Machine 1
Place the original on the platen glass.
Original and Paper
Description
2
Copying
3
Action
Sending and Platen Glass is dirty.
Receiving 4
Description
Printing and
Action
Scanning
5
Remove the original from the feeder.
Network (imageCLASS
MF7480/MF7470 Only) 6
Description
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
Action
System Settings
Remove the paper from the output tray.
8
Description
Maintenance
9
Action
Troubleshooting
10
Replace the toner.
Description
Appendix
11
Action
Table of Contents
Index
The specified mode requires that the original be
placed on the platen glass, but there is no
original on the platen glass.
Place the original on the platen glass.
The feeder's scanning area is dirty.
Clean the feeder's scanning area. (See "Manual
Feeder Cleaning," on p. 9-5.)
The machine cannot scan your original using the
feeder. An original is placed in the feeder and on
the platen glass.
Remove the original from the feeder.
Prints from the previous job remain in the output
tray.
Remove the prints remaining in the output tray.
Printing automatically resumes.
Printing is not possible because the toner has run
out.
Replace the cartridge. (See "Replacing the
Cartridge," on p. 9-12.)
Back
Return page 1 to the top, and then press the Start key.
Description Scanning was stopped due to a problem with the
feeder.
Action Arrange the originals in page order with the first
page on top. Place the originals back into the
feeder's original supply tray, and press
Set the IP Address. (imageCLASS MF7480/MF7470 Only)
Description This machine is not set with an IP address.
Action Specify the IP Address Settings in TCP/IP Settings
in Network Settings in System Settings (from the
Additional Functions screen), then turn the
machine's main power off and back on again.
(See "IP Address Settings," on p. 6-40, or "Set the
Machine for Network Usage (imageCLASS
MF7480/MF7470 Only)," in the Starter Guide.)
There are too many subdirectories.
Description You have exceeded the maximum number of
subdirectory levels allowed.
Action The directory level that you are trying to access
cannot be specified. Specify a different
destination.
TOP
Previous Next
(Start).
10-20