Print Problems - Canon imageCLASS MF7460 Reference Manual

Before Using the
Machine 1
Original and Paper
2
Copying
The machine does not work.
3
Sending and
Receiving 4
Printing and
Scanning
5
You cannot print a job or store a job.
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Paper excessively curled after coming out ouf the machine.
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Is there paper in the drawer or the stack bypass?
A Load paper.
Q Does any message appear on the touch panel
display?
A Act appropriately according to the message.
Q Is the total number of pages in all jobs within the
limit which can be processed?
A Delete other processes, cancel other jobs being
processed, or wait until those jobs are finished, then
print again.
A Divide the job, then print again.
Q Does your paper curl too easily?
A Ensure that the paper you are using meets the
specifications. Remove the paper stack, turn it over,
reload in the drawer and try again. (See "Paper
Requirements, " on p. 2-10.)
Back
Blank paper comes out from the machine.
Q Have you removed the plastic seal from the
cartridge?
A Make sure you remove the seal from the cartridge.
(See "Install Cartridge, " in the Starter Guide.)
Q Is the cartridge installed properly?
A Make sure the cartridge is installed properly. (See "Set
Up the Machine, " in the Starter Guide.)
Q Is the cartridge out of toner?
A Replace the cartridge. (See "Replacing the Cartridge, "
on p. 9-12.)

Print Problems

■
Printer not using the font you want.
Q Have you specified an available font?
A Check whether the font you specified is available with
the machine. (See "Typeface Samples, " on p. 11-56 and
"Symbol Sets, " on p. 11-58.)
TOP
Previous Next
10-44