Canon imageCLASS MF7460 Reference Manual page 403

Before Using the
Machine 1
Printer Settings
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
6. PAGE LAYOUT
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
1. IMAGE REFINEMENT
2. DENSITY
3. TONER SAVER
1. BINDING
2. MARGIN
Sets whether to print smoothly the jagged outlines of characters and graphics.
– ON
– OFF
The results of image refinement may be different depending on the types of characters and graphics you
want to print.
Adjusts the print density. (1-9)
Sets whether the toner saving mode is enabled.
– OFF
– ON
If [ON] is selected for Toner Saver, very light or finely detailed images may not be printed clearly.
Sets the printing layout.
Sets the binding position for two-sided printing.
– LONG EDGE
– SHORT EDGE
– You cannot create a binding margin with this setting alone. Use this setting in combination with the
Margin setting to create a binding margin.
– For two-sided printing, the orientation of the image on the back side of the page may be changed by
this setting.
Sets the page margin in inches or millimeters.
– INCHES (-01.90INCHES–01.90INCHES)
– mm (-50.0 mm–50.0 mm)
– If this setting moves the image outside the printable area, part of the image may be cut off.
– Pressing [▶] increases the setting value by 0.01" (0.5 mm) each time the key is pressed. Pressing [◀]
decreases the value by 0.01" (0.5 mm) each time. Holding down either [◀] or [▶] continuously speeds
up the value alteration.
Back Previous Next
TOP
11-20