Sending And Receiving - Canon imageCLASS MF7460 Reference Manual

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
– Do not force a jammed original or paper out of the machine. Contact
Canon Customer Care Center if needed.
– When a paper jam occurs in the feeder, you cannot continue operating
the machine. Follow the instructions on the touch panel display to
remove the jammed paper. (See "Feeder, " on p. 10-5.)
– If paper is jammed in several locations, remove the jammed paper in the
order indicated on the touch panel display.
1.
Inspect all paper jam locations indicated on the
touch panel display, and remove any jammed
paper.
See the appropriate pages below for instructions on finding and
removing jammed paper. Or, you can follow the instructions on the
touch panel display.
If jammed paper tears while it is being removed, be sure to remove
any remaining pieces from inside the machine.
– If the machine's power is turned off when there is a paper jam,
detection of paper jams in the paper drawers is not possible after
the power is turned back on. Clear paper jams without turning
the power off.
– Some areas that are shown to have paper jams may not actually
have paper jams. However, always check all locations indicated
on the touch panel display in the order that is given.
– When paper is jammed in several locations, the following image
with the black circles appears on the screen.
Back Previous
① Feeder (See "Feeder, " on p. 10-5.)
② Stack Bypass (See "Stack Bypass, " on p. 10-7.)/Fixing Unit (See
"Fixing Unit (Inside the Main Unit), " on p. 10-8.)
③ Duplex Unit (See "Duplex Unit, " on p. 10-11.)
④ Paper Drawer 1 (See "Paper Drawer 1, " on p. 10-13.)
⑤ Paper Drawer 2 (See "Paper Drawer 2, " on p. 10-15.)
2.
After you have removed all of the jammed paper
in the locations indicated on the touch panel
display, restore all levers and covers to their
original positions.
3.
Continue to follow the procedure and
instructions on the touch panel display.
Once you have cleared all of the jammed paper in locations other
than the feeder, printing or copying resumes.
If there is paper that still needs to be removed, a screen indicating
how to clear that paper jam appears on the touch panel display.
Repeat the procedure from step 1.
You do not have to re-enter the number of copies or prints, even if
you are printing multiple sets. The machine automatically
recalculates the number of copies or prints to make based on the
number of sheets that have jammed.
TOP
Next
10-4