Canon imageCLASS MF7460 Reference Manual page 194

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
If you want to print a job with a forwarding error:
●
– Select the job you want to print, then press [print].
– Press [Yes].
– If you do not want to print the document, press [No].
– The selected document is printed.
If you want to transfer a job with a forwarding error:
●
– Select the job you want to transfer, then press [Forward].
– Specify the destination from the Address Book, then press [Start].
– If the job that you want to select is not displayed, press [▼] or
[▲] to scroll to the desired job.
– To erase multiple documents from memory, select and erase one
document at a time.
– To print multiple documents, select and print one document at
a time.
– If the transfer is successful, the document is erased from memory.
– For instructions on using the Address Book, see "Using the
Address Book, " on p. 4-27.
– You cannot select a group address for transferring the document.
3.
Press [Done] repeatedly until the Send Basic
Features screen appears.
Back Previous
Erasing Received I-Fax Documents
You can erase any received I-fax document stored in memory. If the
memory is full, the machine cannot receive any documents. It is
recommended that you erase unnecessary documents as often as
possible.
Additional documents cannot be received in memory when either of the
following is true:
– When a total of 64 documents or images have been stored or received in
memory
– When a total of approximately 1,000 pages of documents or images have
been stored
1.
Press [System Monitor] → [RX/TX] → [RX Job
Report] → [I-Fax Mem. Lock Doc.].
The I-FAX Memory Lock Document screen appears.
2.
Select the document you want to erase, then
press [Erase].
– If the job that you want to select is not displayed, press [▼] or
[▲] to scroll to the desired job.
– To check the details of the job, press [Details].
– To erase multiple documents from memory, select and erase one
document at a time.
3.
Press [Yes].
If you do not want to erase the document, press [No].
The message <Erasing...> appears for approximately two seconds on
the touch panel display.
The selected document is erased.
4.
Press [Done] repeatedly until the Send Basic
Features screen appears.
TOP
Next
4-83