Copying Problems - Canon imageCLASS MF7460 Reference Manual

Before Using the
Machine 1

Copying Problems

Original and Paper
2
Blank paper comes out from the machine.
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Copy is too light or has uneven density.
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Have you removed the plastic seal from the
cartridge?
A Make sure you remove the seal from the cartridge.
(See "Install Cartridge, " in the Starter Guide.)
Q Is the cartridge installed properly?
A Make sure the cartridge is installed properly. (See
"Install Cartridge, " in the Starter Guide.)
Q Is the cartridge out of toner?
A Replace the cartridge. (See "Replacing the Cartridge, "
on p. 9-12.)
Q Is the toner low or unevenly distributed?
A Redistribute the toner inside the cartridge. If the
problem persists, replace the cartridge. (See
"Replacing the Cartridge, " on p. 9-12.)
Back
Copy has vertical white streaks.
Q Is the toner low or unevenly distributed?
A Redistribute the toner inside the cartridge. If the
problem persists, replace the cartridge. (See
"Replacing the Cartridge, " on p. 9-12.)
Copy is spotted or dirty.
A If the copy is spotted or dirty, clean the scanning
components and machine's interior (See "Cleaning the
Machine, " on p. 9-2.)
Paper jams occur.
A Make sure the scanning platform and all covers on the
machine are fully closed. (See "Clearing Jams, " on
p. 10-3.)
Is the paper loaded correctly?
Q
A Make sure the document is correctly loaded. For
details on how to load paper in the paper drawer, see
"Set Up the Machine, " in the Starter Guide. For details
on how to load paper the stack bypass, see "Loading
Paper, " on p. 2-13.
Q Is the correct type of paper loaded in the machine?
A Make sure you load paper that meets the
requirements for use. (See "Paper Requirements, " on
p. 2-10.)
TOP
Previous Next
10-40