Canon imageCLASS MF7460 Reference Manual page 98

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
6.
Select the size of the bound original when it is
open, then press [Next].
– You can set the Book Frame Erase mode only for the original
paper sizes shown on the touch panel display.
– To select an A or B series paper size, press [A/B-size].
7.
Press [-] or [+] to set the frame erase widths.
– To enter values in millimeters, press [mm].
– When entering values in millimeters, you can also use
(numeric keys), and (Clear) to clear your entries.
– You can change the values by pressing [-] or [+], even if you have
entered the values using –
– If you enter a value outside the setting range, a message
prompting you to enter an appropriate value appears on the
screen.
– The maximum book frame erase width that you can set is <1
15/16" (50 mm)>.
If you want to set the same width for all four borders:
●
– Press [Center] and [Sides].
– Press [-] or [+] to set their respective frame erase widths, then
press [OK].
If you want to set the top, left, center, right, and bottom
●
widths independently:
– Press [Adjust Each Dim.].
– Select the desired frame erase borders.
– Press [-] or [+] to set their respective frame erase widths, then
press [OK].
To return to the screen for setting the same width for all four borders,
press [Adjust All At Once].
8.
Press [Done].
–
(numeric keys).
Back Previous
9.
Press (Start).
– To cancel this setting, press [Special Features] → [Frame Erase] →
[Cancel].
– To cancel all settings and return the machine to the Standard
mode, press (Reset).
Binding Erase
This mode erases the shadows that appear on copies from binding
holes on originals.
– The Binding Erase mode cannot be used with the Book ▶ 2-Sided, Two-
page Separation, or Different Size Original mode.
– Do not place originals with binding holes into the feeder, as this may
damage the originals.
– If you are using the Binding Erase mode, the borders you do not select
are also slightly erased.
1.
Press (COPY).
2.
Place your original on the platen glass.
3.
Press [Special Features].
4.
Press [Frame Erase].
5.
Press [Binding Erase], then press [Next].
6.
Select the border where the binding holes are
located, then press [Next].
The border is where the binding holes are located on the original, if
you visualize the original as being face up.
TOP
Next
3-27