Roland TrueVIS VG3-640 User Manual page 95

Setup of Registered Media
1. B: Determine the positions of the media ([Media Edge Detection]: [Disable]).
Use the following procedure to determine the positions of the media when using transparent media, whose
edges cannot be detected, and when [Preferences]>[Media Edge Detection] is set to [Disable].
Procedure
1.
Tap on the operation panel.
The sub power is switched on.
2.
Open the front cover.
3.
Move the media clamps to the outside of the grit rollers on the left and right edges respectively.
4.
(Move to the rear of the printer.) Release the locking mechanisms of the media holders, and then draw
them to the left and right ends respectively.
5.
Pass the leading edge of the media between the pinch rollers (A) and the grit rollers (B).
94
Basic Operations