Roland TrueVIS VG3-640 User Manual page 73

Setup of Registered Media
2. A: Determine the positions of the media.
This section describes how to use the suction fan to prevent media skewing. When using transparent me-
dia, whose edges cannot be detected, and when [Preferences]>[Media Edge Detection] is set to [Disa-
ble], the suction fan does not activate, so media cannot be loaded with this procedure. In these cases,
refer to 2. B: Determine the positions of the media ([Media Edge Detection]: [Disable]).(P.
By default, [Skewing Correction Support at Setup] is set to [Enable].
Procedure
1.
Determine the left and right positions of the media with the grit patterns used as the reference.
Note the following points when determining the positions.
• Hold the media holders from the outside and move them.
• Ensure that the left edge of the media is positioned so that it is within the range of the grit
pattern of the left edge.
• Ensure that the right edge of the media is positioned so that it is within the range of one of the
grit patterns.
CAUTION
Do not hold places other than those instructed. Do not move the media by holding it di-
rectly.
Otherwise the media may fall off the media holder and cause injury.
IMPORTANT
Firmly decide the left and right side positions of the media at this point.
72
Basic Operations
77).