Setup of New Media
(4)
Once the media is taut, additionally take up approximately 10 cm (3.94 in.) of media.
MEMO
If you take up too much media, you will hear two short beeps and the suction fan will stop. Take up the
media, and then redo the procedure from step (1).
4.
(Move to the front of the printer.) Make sure both edges of the media are above the grit rollers.
Be sure to place the right edge of the media on the right-end grit roller.
5.
Move the left and right pinch rollers, placing them on both edges of the media.
Position them approximately 10 mm (0.39 in.) from each edge of the media.
38
Basic Operations