Roland TrueVIS VG3-640 User Manual page 280

2. Make adjustments according to the new blade.
Procedure
1.
Load the media.
2.
Tap [Move].
3.
Tap ,
carry out the cutting test.
You can freely set the location for the cutting test.
4.
Tap [Set Base Point Here].
You are returned to the home screen.
5.
Tap .
6.
Tap [Media Settings]>[Cutting Settings]>[Blade Adjustment].
7.
Tap [Execute] next to [Cutting Test].
The test pattern is cut.
8.
Check the results of the cutting test.
Check item
Check the shape.
Peel off the circle.
Peel off the square.
, , or to move the cutting carriage to the location where you want to
Result
The cut shape is distorted.
The square also peels off.
Some uncut areas remain.
The blade leaves faint traces on the backing
paper.
The blade trace is indistinct.
The blade trace is too deep and cuts into the
backing paper.
Replacing the Blade/Separating Knife
Setting item
[Cutting Speed]
[Blade Force]
[Cutting Speed]
[Blade Force]
Replacing Consumable Parts
Adjustment
Reduce
Increase
Reduce
No change
Increase
Reduce
279