Using the Correction Functions
MEMO
• If the test pattern is difficult to see, tap
position where it is easier to see.
• If you want to hold the media to check the test pattern, tap [Execute] next to [Sheet Cutting] to separate
the media. However, the sheet is cut at the current blade position, so tap
to the desired cutting position, and then tap [Execute].
8.
Tap [Save].
The entered correction values are saved.
9.
Tap [Execute] next to [Printing Test].
The test pattern is printed again.
10.
Check the test pattern to see whether the correction was successful.
For all the correction values, check that the misalignment is minimized for the two vertical lines
indicated by "
set of vertical lines, set the correction value again.
11.
When you have successfully performed the correction, tap
156
Optimizing the Output Quality
P. 105Separating the Media
" (that is, the current correction value). If the misalignment is smaller for another
or
next to [Media Feed] to move the media to a
to go back to the original screen.
to feed the test pattern