Roland TrueVIS VG3-640 User Manual page 91

Setup of Registered Media
5.
From the rear of the printer, pass the leading edge of the media between the pinch rollers (A) and the
grit rollers (B).
You will hear a beep. Approximately 5 seconds later, you will hear two beeps, and then the suction
fan will activate. While this fan is operating, the media will not move backward even if you re-
move your hands from it.
When loading the media from the front of the printer, feed the leading edge of the media (the side
where printing will start) over the platen, and then pull the media to the front to activate the suc-
tion fan.
6.
(Move to the front of the printer.) Make sure both edges of the media are above the grit rollers.
Be sure to place the right edge of the media on the right-end grit roller.
90
Basic Operations