Roland TrueVIS VG3-640 User Manual page 190

7.
Set the correction values in the feed direction of the media (the feed direction) and the direction of
print head movement (the scan direction).
(1)
Tap or
tion of the media (the feed direction).
(2)
Tap or
of print head movement (the scan direction).
8.
Tap [Save].
The correction values are saved.
9.
Tap [Execute] next to [Printing Test 1 (Misalignment Check)].
Printing Test 1 is printed and cut. If the printing and cutting lines are aligned, adjustment is com-
plete. If further adjustment is needed, tap
[Correction Value (Scan)] to fine-tune the printing and cutting position, and then [Save] the val-
ues.
MEMO
Default settings
• [Correction Value (Feed)] (correction value of the media feed direction): 0.00 mm
• [Correction Value (Scan)] (correction value of the print head movement direction): 0.00 mm
10.
Tap to go back to the original screen.
Accurately Adjusting the Settings for Printing and Cutting
next to [Correction Value (Feed)] to set the correction value in the feed direc-
next to [Correction Value (Scan)] to set the correction value in the direction
or next to [Correction Value (Feed)] and
Optimizing the Output Quality
189