Roland TrueVIS VG3-640 User Manual page 55

Setup of New Media
Adjust the reading sensor to the optimal condition. If the adjustment failed, respond to the
failure according to the information in
c. Tap [Next].
d. Perform a printing test on the [Detailed Feed Correction (Manual)] screen.
Set the correction value from the printing test result. For more information, refer to
ual Adjustment: Reducing Horizontal Bands (Feed Correction Function)(P.
e. Tap [Save and Proceed].
f. Perform a printing test on the [Detailed Media Gap Adjustment (Manual)] screen.
Set the correction values from the printing test result. For more information, refer to
ual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjust-
ment)(P.
g. Tap [Save and Exit].
IMPORTANT
When printing and cutting or just cutting, rewind the media from the take-up device to slacken the media.
If sufficient media is not wound on the paper tube immediately after setup, this operation may not be performed well,
lowering the cutting quality and preventing continued take-up. When performing cutting immediately after attaching
the media to the paper tube, first feed enough media to carry out take-up a few times and set the base point.
This completes the setup of the media.
54
Basic Operations
155).
Correcting the Reading Sensor(P. 199).
Man-
153).
Man-