Roland TrueVIS VG3-640 User Manual page 42

2. B: Determine the positions of the media ([Media Edge Detection]: [Disable]).
This section describes how to determine the positions of the media without using the suction fan. Refer to
this information when using transparent media, whose edges cannot be detected, and when [Preferen-
ces]>[Media Edge Detection] is set to [Disable].
Procedure
1.
Determine the left and right positions of the media with the grit patterns used as the reference.
Note the following points when determining the positions.
• Hold the media holders from the outside and move them.
• Ensure that the left edge of the media is positioned so that it is within the range of the grit
pattern of the left edge.
• Ensure that the right edge of the media is positioned so that it is within the range of one of the
grit patterns.
CAUTION
Do not hold places other than those instructed. Do not move the media by holding it di-
rectly.
Otherwise the media may fall off the media holder and cause injury.
IMPORTANT
Firmly decide the left and right side positions of the media at this point.
After this procedure is completed, if the left and right side positions do not fit the proper positions when se-
curing the media with pinch rollers, you will have to go back to this step to redo this procedure. If you just
Setup of New Media
41
Basic Operations