Roland TrueVIS VG3-640 User Manual page 197

Accurately Adjusting the Settings for Cutting with Crop Marks
2. Print only the crop marks.
Procedure
1.
Tap .
2.
Tap [Media Settings]>[Cutting Settings]>[Crop Cut Position Adjustment].
3.
If
4.
Tap [Execute] next to [Printing Test].
Printing of the test pattern starts.
The crop marks are printed. When printing is finished, you will return to the original screen.
5.
Remove any media.
Use the following procedure to separate the media.
(1)
Close the front cover.
(2)
Tap [Change] next to [Output Start Location].
(3)
Tap
crop marks.
(4)
Tap
(5)
Tap [Execute] next to [Sheet Cutting].
(6)
Tap [Yes] on the confirmation screen.
6.
Complete operations before cutting output for normal cutting with crop marks, such as laminating.
196
Optimizing the Output Quality
next to [Separate Test for Printing/Cutting with Crop Marks] is off, tap it to turn it on.
to feed the media until there is a margin of 130 mm (5.12 in.) or more after the printed
to go back to the previous screen.