Roland TrueVIS VG3-640 User Manual page 146

MEMO
• When you send the output data, [Ink circulation in progress.] or [Normal cleaning in progress.] may be
displayed on the screen. These indicate the preparation operations performed before output. Output will
begin after the time displayed on the screen elapses.
• If [Heater warm up in progress. Please wait.] is displayed, wait until the set temperature is reached.
• The data being output can be viewed as an image. Tap
remaining ink screen. Tap this icon again to return to the screen for checking the data being output. How-
ever, this functionality is limited to software RIPs that support the display of the output data image
(thumbnail).
IMPORTANT
Output Is Not Possible in These Situations
• The machine does not run when a cover (front, left, or right) is open.
• Data from the computer is not accepted when [Load media.] is displayed.
• Output does not start while [Heater warm up in progress. Please wait.] is displayed.
• On menu screens where [Menu operation in progress: Press [Home] to enable output.] is displayed, out-
put doesn't start even when data is sent from the computer. When you return to a menu item where output
is possible or tap
Points that must be observed
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• When you are performing printing, clamp the edges of the media with the media clamps. Otherwise, the
edges of the media may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub
against the print heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
When not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely affect
printing. When not using the machine, remove any media and store it in a suitable environment.
RELATED LINKS
・ P. 168 Setting the Print Heater Temperature
・ P. 170 Setting the Dryer Temperature
・ P. 176 Switching Off the Print Heater and Dryer Together
to return to the home screen, output starts.
Starting Output with Crop Marks
shown in the following figure to switch to the
How to Cut with Crop Marks
145