Table of Contents
Advertisement
12.3
SCALPING _____________________________________________________
NOTE: Arrow indicates direction of travel.
Possible Cause
The HOC (height-of-cut) settings are low for the
conditions.
The mower cannot follow the ground in this direction.
The height of grass is being reduced too much in
one pass.
Damaged anti-scalp skid/roller
Rotary Deck caster stance too wide
"Scalping" is a condition in which some areas are cut
shorter than the set height of cut. This results in very
short grass or brown areas. The cause is a low
height-of-cut (HOC) setting, rough surface.
TN0222
Check and adjust the HOC settings.
(See section 9.3)
Change the direction of cut.
Mow more often or raise the height of cut.
Replace or repair
Move deck caster towards the centre of the deck
QUALITY OF CUT 12
Correction
en-115
Advertisement
Table of Contents
