Table of Contents
Advertisement
MAINTENANCE AND LUBRICATION 8
8.17
WHEEL MOUNTING PROCEDURE ____________________________________
WARNING
Make sure the mower is parked on a solid and level surface. Never work on a mower that is supported
only by the Jack. Always use Axle Stands.
If only the front or rear of the mower is lifted, put the chocks in front of and behind the wheels that
are not lifted.
Remove dirt, grease and oil from the stud threads. Do not lubricate threads.
1
4
Put the wheel on the hub. Inspect the wheel to make sure of full contact
between surface of wheel and hub.
3
2
5
Tighten all hardware with your fingers, then torque hardware in the order
shown. When possible, tighten nuts in the top position.
Check and torque hardware each day until the following torque is kept:
1
4
Front - 102-122 Nm (76-90 lbf-ft).
3
2
Rear - 65-85 Nm (48-62 lbf-ft).
en-89
Advertisement
Table of Contents
