Table of Contents
Advertisement
9 ADJUSTMENTS
9.4
BLADE CHANGE ________________________________________________
1.
Raise the deck so it is just clear of the ground.
This will allow the setting pin D to lift clear of the
arm and be easier to remove.
2.
Remove the pins at position D on both sides of the
machine which lock the deck in its working
position.
3.
Lift the cutter deck to its full height.
4.
Rotate cutter deck to the vertical position.
5.
Insert one of the height of cut pins at position (E) to
lock deck in its vertical position.
6.
Remove blade (B) from deck.
7.
Fit new blade. It is advisable to replace blade
hardware at same time.
8.
Tighten blade bolt with torque wrench (C) set to
95N-m (70 ft.-lb.) torque.
9.
Support the deck then remove the pin which holds
the cutter deck in the vertical position and return
deck to its working position.
10. Refit the locking pins to position (D).
Blades are extremely sharp and can cause
severe cuts. For your protection, hold blades
with suitable protective gloves only.
Note: It is recommended to replace blade hardware
when fitting new blade.
en-96
WARNING
D
E
B
A
C
Advertisement
Table of Contents
