Table of Contents
Advertisement
CONTROLS 6
6.6.4 WARNING SLOPE ANGLE – INHIBIT CUT ________________________________
If the slope angle reaches 24° the screen will display this warning to
indicate that the cutters have been switched off and disabled.
An audible warning will sound continuously for 4 seconds at 4 second
intervals, and the red LEDs will flash continuously for 4 seconds at 4
24
second intervals. This will continue until the machine has been
1/1
driven onto an area of less than 20°.
6.6.5 WARNING OIL PRESSURE FAULT ______________________________________
When this screen is shown, the engine oil pressure has decreased below
the normal level. If this happens during operation, or does not go off when
the engine is run at more than 1000 rpm. Stop the engine and check the
oil level. Top up if necessary.
If the fault persists, do not use the machine at all and contact your local
Ransomes Jacobsen dealer.
1/1
6.6.6 WARNING ENGINE OVERHEAT ________________________________________
When this screen is shown, the engine
temperature has risen above the normal
1234
123.4 Hours
P
levels.
Park the machine in a safe area
TM
disengage cutting implements, set engine
1/1
to idle to allow engine temperature to
decrease prior to switching off the engine.
Clean the radiator and screens of all
grass and debris.
en-47
Advertisement
Table of Contents
