Table of Contents
Advertisement
12.9
INCONSISTENT UNCUT PATCHES _________________________________
Possible Cause
Damaged or missing blades.
Extreme volume of grass is not discharged quickly
enough from the deck.
Cutting at more than the recommended speed.
The Height of grass is being reduced by too much in
one pass.
Incorrect deck rake angle.
Poor ground following due to ground undulations.
"Insufficient Mulching." This problem is identified by
long lengths of random clumps of uncut grass.
TN1278
Check and replace damaged blades or try
Eliminator blades.
Consider using a cut and clear kit
(152cm rotary deck only).
Decrease the cutting speed.
Mow more often or raise the height of cut.
Ensure the rear of the deck is set correctly. Then if
issue persists increase the rake angle by raising the
rear of the deck by one hole.
Cut in different direction.
QUALITY OF CUT 12
Correction
en-121
Advertisement
Table of Contents
