Table of Contents
Advertisement
6 CONTROLS
6.5.3 CROSS CUT ________________________________________________________
Cross Cut function raises the cutting implement to a partially raised posi-
tion, allowing the operator to avoid obstructions without having to fully lift
the cutter deck. The Cutter PTO will disengage within 3 seconds of reach-
ing Cross Cut position. If lowered again within 2 minutes the Cutter PTO
will re-engage automatically. After 2 minutes of continued use in Cross
Cut the PTO will have to be manually reactivated using the PTO switch.
To activate Cross Cut, with the cutting implement in lowered position
move the Lift /Lower switch momentarily to the rear in a quick motion. To
deactivate, move the switch lever fully forward. refer to (section 6.7)
Using the PIN Menu Buttons 2 and 3 to arrow up and down, and Button
4 to select Cross Cut, this gives you the option to Enable or Disable
• Disabled - The implement will only lift while the lift joystick is held
• Enabled - The implement will lift to a predetermined height with a short single activation of the lift joystick
6.5.4 TRACTION BOOST __________________________________________________
Using the PIN Menu Buttons 2 and 3 to arrow up and down, and Button
4 to select Traction Boost, this gives you three options
• Disabled - Traction Boost is switched off.
• Momentary - Traction Boost is only active while the Traction Boost
button on the armrest pod is pressed.
• Maintained - Traction Boost can be turned on permanently by
pressing the Traction Boost button or the armrest pod
6.5.5 INCLINOMETER _____________________________________________________
Using the PIN Menu Buttons 2 and 3 to arrow up and down, and Button
4 to select Inclinometer and this gives you the option to Enable or
Disable TST™
Note: If TST™ is installed, but disabled via the screen, the machine angle
when greater than 16° will be displayed, however no alarms or physical
interventions will occur.
If TST™ is not installed then Not Installed will be displayed on this
screen and the Disabled and Enabled options will be greyed out.
en-44
Cross Cut
Disabled
Enabled
Traction Boost
Disabled
Momentary
Maintained
Inclinometer
Disabled
Enabled
Not Installed
Advertisement
Table of Contents
