Table of Contents
Advertisement
3.Connect the deck hoses to the machine by either –
a. Attaching the hard routed motor hoses directly to the Cutter Valve (ensure the hoses are routed
through the Guide Loop)
i. The hose from the LH motor connects to the Cutter Valve port A
ii. The hose from the RH motor connects to the Cutter Valve port B
iii.The smaller drain hose connects to the Drain Manifold T-Piece C
b. Attaching the hoses supplied with Quick Release Couplings (QRC) to the ports found on the
QRC Bulkhead
i. The hose from the LH motor connects to the LH QRC port (coloured red)
ii. The hose from the RH motor connects to the RH QRC port (coloured yellow)
iii.The smaller drain hose connects to the Drain port in the centre
4.See (section 9.3) to set the Height of Cut.
QRC
Bulkhead
Deck QRC
A
C
B
Guide
Loop
Deck QRC
OPERATION 7
en-61
Advertisement
Table of Contents
