Table of Contents
Advertisement
7 OPERATION
7.8
MOWING__________________________________________________________
1. Ensure speed limiter is in mow position.
2. Lower the cutting implement.
3. Engage the cutting mechanism by pressing the cutting PTO switch forward.
4. Release the Park Brake and begin driving forward.
NOTE: Always set the throttle to full engine revs for mowing, even when the grass is heavy. When the engine is
labouring, reduce forward speed by easing back on the FWD/REV foot pedal. A performance indicator lamp on
the control pod will illuminate red as the cutter deck starts to labour.
7.9
TO STOP THE ENGINE ______________________________________________
1. Disengage drive to the cutting implements with the cutting implement / PTO switch.
2. Remove foot from the FWD/REV pedal.
3. Set the Park Brake.
4. Move the throttle control lever to the SLOW position.
5. Turn the ignition key to OFF.
7.10
UNBLOCKING CUTTER IMPLEMENTS _________________________________
1. Switch off cutter deck, lift out of work and move machine to flat level ground.
2. Switch engine off and remove the ignition key.
3. Pivot deck see section 9.4.
4. Using an appropriate tool and recommended PPE, ensuring a local risk assessment is carried out before
removing blockage.
5. Check blades for damage and replace if necessary.
6. Put deck back into operating position see section 9.4.
7. Start engine and decks to check for correct operation.
en-64
Advertisement
Table of Contents
